Fast, Reliable Attic Insulation Across Irving
Attic insulation in Irving typically costs $1,800 – $4,200 for a full attic, depending on square footage, current R-value, and whether you need removal or just a top-up. Most jobs are completed in one day, and we answer the phone 24/7 at (940) 748-1726. Our crews work Irving from Valley Ranch to Las Colinas to the older east-side tracts, and we show up inside the window we promise, with a written price in your hand before any tool comes off the truck.
If you live in Irving, you already know the summer drill: the upstairs runs five to eight degrees warmer than downstairs, the AC never cycles off in August, and the electric bill climbs every year. That’s not just Dallas-Fort Worth heat. In most Irving homes, it’s an attic that’s under-insulated, settled, or missing air sealing altogether. We fix that in one trip.
Why Alden Insulation Dallas Is Irving’s Preferred Attic Insulation Company
We’re part of the Garrison Partners family, established in 2002, and every Irving job is held to The Garrison Standard: a written price before work begins, a written guarantee good for 365 days, and a background-checked, uniformed crew that shows up when we said we would. That discipline matters here. Irving homeowners have been burned by contractors who quote one number over the phone and revise it at the door. We don’t do that.
Bryce Holloway runs our operation, and he built the Irving service area on a simple rule: do the job by the book, write everything down, and stand behind it for a full year. If our attic insulation work fails within 365 days, we come back at no charge. That’s the 365-Day Done Right Promise, and it’s in writing on every job we do in Irving. No fine print, no exclusions beyond what’s already spelled out before you sign.
Our technicians know Irving’s housing stock block by block. They know the 1970s brick-veneer tract homes in east Irving with original R-11 batts. They know the two-story subdivisions where attic hatches were never weatherstripped and can lights leak conditioned air into the attic all summer. That local knowledge means we diagnose correctly the first time, not after three return visits.
Radiant Barrier in Irving
Radiant barrier in Irving is a foil-faced material installed on the underside of your roof rafters that reflects radiant heat away from the attic floor, and it’s one of the single most effective upgrades for our climate. During an Irving summer, attic temperatures without a radiant barrier routinely hit 140°F to 160°F. With a properly installed barrier, that drops 20 to 30 degrees. That means your AC works less, your ductwork sits in cooler air, and the upstairs bedrooms finally catch up with the rest of the house. Radiant barrier installation in Irving typically runs $1,200 – $2,800 depending on attic size and accessibility.
Where It Works Best in Irving
Radiant barrier makes the biggest difference in attics with HVAC equipment and ductwork in the unconditioned space, which covers most Irving homes built before the early 2000s. If your upstairs runs warm even after adding insulation, the problem is often radiant heat loading, not just low R-value. We install radiant barrier on the rafters, keeping it off the roof deck to allow airflow, and we’ll tell you honestly if your attic layout won’t benefit enough to justify the cost.
What We Pair It With
Radiant barrier works best when the attic floor insulation and air sealing are already correct. On most Irving jobs, we’ll recommend air sealing the top plates, can lights, and attic hatch first, then topping off blow-in insulation to R-38, and finally adding the radiant barrier. That sequence stops the three heat paths into your home at once: conduction through the ceiling, air leakage through penetrations, and radiant heat from the roof deck.
Attic Cleaning Services in Irving
Attic cleaning services in Irving mean removing old, settled, or rodent-damaged insulation, vacuuming the attic floor, sanitizing where needed, and preparing the space for new insulation, and it’s a job we handle for Irving homeowners regularly before a top-up or full re-insulation. If you’ve had rodents or wildlife in the attic, or if your old blown-in fiberglass is packed with dust, droppings, and debris, adding new insulation on top of it doesn’t solve the problem. Attic cleaning and insulation removal in Irving typically runs $1,500 – $3,500 depending on attic size and the condition of the existing material.
When You Need It First
In Irving’s older east-side homes, we often find original insulation that’s been compressed by decades of service traffic, cable installs, and roof repairs. In Valley Ranch and Las Colinas, the original blown-in fiberglass from the 1980s and 90s has often settled below the joist tops entirely. Topping off without addressing the settled layer leaves thermal bridges at every joist. We’ll tell you straight whether cleaning and removal is necessary or whether a top-up over the existing material will do the job.
The Removal Process
Our crew uses commercial insulation vacuums to remove old material cleanly, bag it, and haul it out. We don’t leave a mess in your hallway or your landscaping. Then we inspect the attic floor for air leaks, seal what needs sealing, and install new insulation to the R-value your home needs. Every removal job in Irving includes the written guarantee and the same 365-Day Done Right Promise as a new install.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Irving
We install and service insulation from brands you can research on your own before you sign anything. In Irving attics, we regularly work with Rockwool stone wool, CertainTeed fiberglass, Icynene spray foam, and Demilec closed-cell spray foam. When a homeowner in Valley Ranch needs an R-38 blown-in top-up, we can quote Owens Corning or Johns Manville. When a Las Colinas homeowner needs air sealing plus open-cell foam, we spec Icynene. And we keep material stocked at our Dallas-Fort Worth office so we don’t lose a day waiting on a supplier. You’ll know exactly what’s going into your attic, by name, before the job starts.
Common Attic Insulation Problems We See in Irving Homes
- Settled blown-in fiberglass in Valley Ranch and Las Colinas. Original blown-in insulation from the 1980s and 90s has often sunk below the tops of the ceiling joists. That leaves a thermal bridge at every joist bay, and your thermal camera would show a stripe of heat along each joist on a summer afternoon.
- Clay soil movement cracking slab-on-grade homes. Irving’s expansive clay soil shifts with moisture cycles, and over decades that movement opens hairline cracks at wall top plates and around attic hatches. Humid outside air infiltrates the attic, causing condensation and, in bad cases, mold on the underside of the roof deck.
- Original R-11 batts in 1970s east Irving tract homes. Fiberglass batts rated R-11 were code minimum in the 1970s, and most have been compressed under roof decking or shoved aside during cable and ductwork retrofits. Effective R-value in many of these attics is half what the label says.
- Missing air sealing at can lights and top plates. Even in newer west Irving homes built to later code, the attic floor is rarely sealed well. Can lights, ceiling fans, and interior wall top plates pump conditioned air into the attic all summer, which pulls hot, humid outdoor air into the house through the building envelope.
Pricing for Attic Insulation in Irving, TX
Here’s what Irving homeowners can expect, in real numbers. A straightforward blown-in top-up to R-38 in a 1,500-square-foot attic runs $1,800 – $2,600. A full attic insulation replacement, including removal of old material, air sealing, and new blown-in fiberglass or Rockwool to R-38, runs $3,200 – $4,500. Adding radiant barrier on the rafters adds $1,200 – $2,800 depending on attic size. Attic cleaning before a top-up adds $1,500 – $3,500 depending on the condition and volume of existing material. Every quote is written, itemized, and in your hand before work starts, and every quote is the price you pay. No adjustments at the door, no surprise line items at invoice. Call (940) 748-1726 for a free estimate specific to your attic.
We Also Serve Cities Near Irving
Our crews cover the full Dallas-Fort Worth perimeter around Attic Insulation in Irving, including Dallas, Hutchins, Grand Prairie, and Cedar Hill. If your home sits in one of those surrounding cities, the same written pricing, 365-Day Done Right Promise, and one-trip service apply. We dispatch from our Dallas-Fort Worth office and schedule Irving jobs daily.
Serving Irving, TX - Our Local Coverage Area
We’re based in the Irving area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Attic Insulation in Irving
Your attic feels hot because the original blown-in fiberglass has settled below the tops of the ceiling joists, leaving thermal bridges at every joist, and because the roof deck radiates heat straight down onto whatever insulation is there. Radiant barrier addresses the radiant heat from the roof deck and typically cuts attic temperatures by 20 to 30 degrees in an Irving summer. It works best when paired with air sealing and a top-up of the settled insulation, which is how we spec it on most Valley Ranch and Las Colinas homes. Call (940) 748-1726 and we’ll tell you if your attic layout justifies the cost.
Irving’s expansive clay soil expands and contracts with seasonal moisture changes, and over 30 to 50 years that movement cracks slab-on-grade homes at wall top plates, around attic hatches, and along ceiling lines. Those cracks let humid outdoor air infiltrate the attic, which condenses on the underside of the roof deck and degrades insulation performance. A proper air sealing job at the attic floor stops that infiltration, and we inspect for those exact gaps on every Irving attic project.
In most Irving homes, you can top off settled blown-in fiberglass without removing it, as long as the existing material is dry, free of rodent activity, and not compressed into a dense mat. If the old insulation is wet from condensation, packed with droppings, or full of dust from decades of air leakage, removal is the better call. We’ll evaluate it during the estimate and tell you honestly which path makes sense for your attic.
Look for hot spots on your ceiling in the summer, especially in the upstairs bedrooms. If you can feel warmer stripes that line up with the ceiling joists, or if one room runs consistently hotter than the next, settled insulation is the likely cause. Our technicians can confirm it in minutes with a thermal imaging camera, and we’ll show you the images so you’re not taking anyone’s word for it. Call (940) 748-1726 for a free inspection.
For Irving’s climate, the current DOE recommendation for attics is R-38 to R-60, with R-38 being the realistic minimum for a home that’s also getting air sealing and radiant barrier. Most original Irving attics sit at R-11 to R-19, which is why upstairs rooms run so hot. We typically bring attics to R-38 in one trip, and we’ll quote R-49 or R-60 when the budget and attic depth allow it.
One Trip, Done Right, in Writing
Irving’s particular problem is the hot attic that nobody explained. The house was built in 1983 or 1994, the builder put in code-minimum insulation, the clay soil has been moving for thirty years, and the original material has settled or compressed to half its rated value. Fixing that properly means air sealing the penetrations, topping off the floor insulation to R-38, and adding radiant barrier where the attic layout calls for it. That’s one trip, one written price, and one written guarantee that covers the work for 365 days. If it fails within that year, we come back free. That’s The Garrison Standard, applied to every attic we work in across Irving.
Call (940) 748-1726 and a live person answers, 24 hours a day. We’ll schedule a free estimate, show up in uniform, and hand you a written price before any work begins. No voicemail tag, no vague half-day windows, no revision at the door. Just a straight answer about what your attic needs and what it costs to fix it.
Written by Bryce Holloway, Owner at Alden Insulation Dallas, serving Irving and the surrounding Dallas-Fort Worth area.